Instruction Manual
LB55932T/R
WARNING
STRANGULATION HAZARD -
Children have STRANGLED in cords.
Keep this cord out of reach of children (more than 3 feet/1 meter away
from the crib). Never use extension cords with AC adapters. Only use the
AC Adapters provided.
WARNING
Adult assembly required. Keep small parts
away from children when assembling.
Warning Information
*Keep this instrucon manual for
future reference.
*For adult use only.
WARNING
·When an AC Adapter is plugged into an electrical outlet, do not the exposed end.
·Test baby monitor before first use, periodically, and when changing locaon of the baby unit(Camera).
·Do not use monitor near water (Such as bathtub, Sink, etc)
·Keep parent unit away from heat sources (Such as stoves, radiators, etc)
·Make sure there is proper venlaon around baby unit and parent unit.
·This product is not a toy. Do not allow children to play with it.
·The mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
·The baby monitor should not be considered as a medical dev
ice. While using the baby monitor, it is
strongly recommended to have an adult directly checking on your baby. Premature babies or children
considered at risk must be supervised by your pediatrician or other medical staff.
THIS PRODUCT CANNOT REPLACE
RESPONSIBLE ADULT SUPERVISION
·Use only the original rechargeable baery provided.
·Do not shot-circuit supply terminals.
·Remove baery when product is stored for long periods of me or when ba ery is exhausted.
·Dispose of exhausted baery properly.
·Keep all baeries away from children.
·The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such
as vases, shall be placed on the apparatus.
·Danger of explosion if baery is incorrectly replaced. Replace only with the same or equivalent type.
·Baeries (baery pack or baeries installed) shall not be exposed to excessive heat such as sunshine, fire
or the like.
Baery Warning
Precauons
·Do not overload wall outlets, extension cords, or integral convenience
receptacles as this can result in a risk of fire or electrics shock.
·The baby monitor works beer in temperature ranging between 0℃
and 40℃ (32℉ and 104℉)
·Do not dismantle the appliance. It does not contain any parts that may
be used independently.
·Never Expose the baby monitor for long period to sun’s direct rays and
never place it next to a source of heat, in a damp or very dusty room.
·Never push objects of any kind into this product through openings as
they may touch dan
gerous voltage points or short-out parts that could
result in a fire or electric shock. Never spill liquid of any kind on the
product.
·Do not aempt to service this product yourself as opening or
removing covers may expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
·The product should be mounted to a wall or ceiling inly as
recommended by the manufacturer.
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following
two condions:
(1) This device may not cause harmful interference
, and (2) This device must accept any
interference received, including interference that may cause undesired operaon.
FCC Cauon
To assure connued compliance, any changes or modificaons not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecng to computer or peripheral devices).
Federal Communicaon Commission Interference
Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instrucons, may cause harmful interference to radio communica-
oons. However, there is no guarantee that interference will not
occur in a parcular installaon. If this equipment does cause
harmful interference to radio or television recepon, which can be
determined by turning the equipment off and on,
the user is
encouraged to try to correct the interference by one of the
following measures:
. Reorient or relocate the receiving antenna.
. Increase the separaon between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Radiaon Exposure Statement
This equipment complies with FCC RF radiaon exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
cenmeters between the radiator and your body.
This transmier must not be co-located or operang in conjuncon with any other antenna or
transmier.
The antennas used for this transmier must be installed to provide a separaon distance of at least
20 cm from all persons and must not be co-located or operang in conjuncon with any other
antenna or transmier.
LBTech’s baby monitor warranty policy
LBTech will repair or replace (at our opon) your unit free of charge
for 12 months from the date of purchase if the unit is defecve in
workmanship or materials. To claim your repair/replacement, the
product must be returned to LBTech together with a copy of the
purchase receipt. In the absence of the purchase receipt, the warranty
will be 12 months from the date of manufacture. This warranty does not
apply to normal wear or damage from misuse, abuse, improper storage
and handling, installaon, accident, unauthorized repair or alteraon.
Please contact our Customer service by Facebook LBTech or via
email for details.
Industry Canada Statement
This device complies with Industry Canada licence-exempt RSS standard.
Operaon is subject to the following two condions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operaon of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitaon est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout brouillage radioélectrique s
ubi, même si le brouillage est suscepble d'en compromere le
fonconnement.
IC Radiaon Exposure Statement:
This equipment complies with IC RSS-102 radiaon exposure limit set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
Cet équipement est conforme aux CNR-102 d'Industrie Canada. Cet équipement doit êtreinstallé et ulisé avec une distance minimale de 20 cenmètres entre le radiateur et votrecorps. Cet
émeeur ne doit pas être co-localisées ou opérant en conjonc
on avec autreantenne ou émeeur. Les antennes ulisées pour cet émeeur doivent être installés eournir une distance de
séparaon d'au moins 20 cenmètre de toute personne et doit pas être co-située ni fonconner en onjoncon avec une autre antenne ou émeeur.
1 meter
Never place the baby unit or the cord
within 1 meter of the crib.
Connect the small plug of the power adapter to the Baby Unit and the other end to a
suitable electrical outlet. Only use the enclosed adapter (5V DC 1000mA).
The baby unit is turned on and the power LED will be blue.
Connecng the power supply for the Parent Unit.
Connect the small plug of the power adapter to the parent unit and the other end to
a electrical outlet. Only use the enclosed adapter (5V DC/1000mA).
Recommend charging me of at least 3 hours before first use.
1
3 4
2
Setup and use your digital video baby monitor
B.
C.
When baery is low, the power on off LED (icon) will flash red and on screen
If you use the parent unit for the first time, when you turn on the parent unit, some boot menus
Notice:
will pop-up on the screen, we try to explation status and function on these menus, please
according to the tips to switch to the monitor system interface. When you are fimaliar with
this monitor, you could switch off these on screen tips in menu.
display baery icon will flash red indicang that the baery needs to be
charged.
Precaution: use of battery for Parent Unit
Only charge the battery when the battery life indicator is low. Constant
recharging of your battery before the low battery indicator light comes on will
decrease the life of your batteries.
Installing Baby Unit
A.
Place Baby Unit on a flat surface, such as a desk or shelf or mount the camera on a wall.
Function of keys and LED indicators Start to use monitor
Parent Unit
Status bar
Menu operation
Baby Unit
When camera is powered on, press and hold ll power LED starng to blink.
Kick Stand
Flip out the kick stand and place the Parent Unit on a
stable, level surface.
Antenna
Microphone
Loudspeaker
USB port
:Camera Antenna
Room Temperature sensor: Gather room temperature informaon.
Pairing button
Battery Door
Open the baery door
to change baery.
Antenna
HW Reset
USB port
Li up antenna to have beer recepon of audio and video.
Short press to turn off the parant unit, and need to restart.
Press to switch on/off Power Saving (voice acvaon mode).
Menu mode (Press to adjust menu sengs)
Press to decrease and increase volume.
Menu mode (Press to select menu option)
Menu mode (Press to adjust menu sengs)
Press and hold to talk to baby unit.
Loudspeaker
Volume down/up
Talk
Up/Down
Left/Right
Select
Power Saving-on/off
Signal strength reference
Camera number
Baby room temperature
Baery level
Talk funcon is acvated
Zoom in is acvated
Monitor is muted
Temperature alert is acvated
Scan view is acvated
Adjust Parent Unit LCD
Brightness lighter or darker.
Adjust camera volume : Sound
level from 1 to 5.
ADD: Add addional camera.
Delete: Delete paired camera from the list.
SCAN: Display paired camera one by one.
View: Select and display the camera.
Quiet: Baby cry a lile bit to acvate the Parent Unit.
Auto
Acvaon sound level selecon in power saving mode.
: Learning environment sound and acvaon. Recommend for
users having white noise machine, fans and lulllabies near by.
Medium: Baby cry moderate to acvate the Parent Unit.
Loud
Sound Bar
: Baby cry louder to acvate the Parent Unit.
Audio on or off opon in power saving mode
: Keep audio connuously
on or OFF when screen is off in power saving mode.
: This sound bar is disigned for deaf parents to reflect sound
level picked up from camera. You can turn visual sound level indicaon
on or off.
boot menu. You can turn the explanaon on or off based on your usage.
High: Beep Alarm
is issued when room temperature is higher than
this seng.
Low: Beep Alarm is issued when room temperature is lower than this
seing.
C
: Display temperature in Celsius scale.
F
Temperature calibraon
: Display temperature in Fahrenheit scale.
ON
: Acvate room temperature alarm funcon.
OFF
: Deacvate room temperature alarm funcon.
: calibrate room temperature display to your
standardized one.
Step 1: Move the parent unit to the same area as the camera. Both parent and baby
unit are switched on.
Step 2: Select ADD in Menu. The next available camera will automacally be
highlighted. Press “Select” to b
egin pairing.
Step 3: Within 10 seconds, press “Pairing buon” of camera.
Step 4: Once successfully paired, the camera light will stop flashing and video will
appear on the monitor screen within 20 seconds.
Baby’s crying sound level
To acvate Parent unit from Power saving mode
Out
In
Zoom
Pair Pairing button
CAM1
2 3 C
INSTRUCTION MANUAL
VOL- VOL+
VOX
23 C CAM1
o
Explanaon On/Off : We try to explaon status and funcon on the
Power on off status LED
Steady Green: Parent Unit is powered on.
Steady Orange: Charging baery.
Flash Red: Baery Low
Power Saving on off status
Steady Green: Power saving mode is acvated.
Sound Level indicator
Visual indicator for sound
picked up from baby unit.
The louder the sound is
from Baby unit, the more
Power Saving-on/off mode
Screen is switched off to save baery
Press and hold to switch “On/Off” the
unit.
energy. When baby cry loud enough,
screen is switched on to display baby’s
video. Baby cry level is adjustable from
Menu seng (Sensivity Level L, M, H,
AUTO).
Short cut to switch camera view
MENU
Microphone
Power
Press this key to view camera 1, camera 2 and etc. paired camera.
Press to open and exit menu opons.
LEDs are light on.
OK
CAM
Reset
VOL-
VOL+
TAL K
TAL K
MENU
CAM
VOX
POWER
VOL-
VOL+
TAL K
MENU
CAM
VOX
POWER
USB CHARGING