Users Manual

21
2.6 Device Connect--Through wired network or wireless network
A. User can connect the indoor monitor through network cable, operation steps:
1.
the keystone jack of network to the end of the 4 pin interface.
2. Connect the outdoor camera(s) and cctv camera(s) to the 4 pin terminal on indoor monitor.
3. Power on the indoor monitor.
4. Wait for a while until hearing a beep sound, then the indoor monitor starts completely.
Network connection diagram through wired network of Figure 1 as an example.
Connect a network conversion with 4 pin interface to JA1 on the indoor monitor, and connect
B. The indoor device with WIFI function can also work in WIFI wireless network.
1. If user connects a network cable to the indoor device, the parameters for WIFI can be set up via
IE browser, please see section for more information, network connection
diagram please refer to Figure 1 on the above.
2. If user doesn’t want to connect a wired cable to the indoor monitor, and user needs to prepare a
wireless router and a smart-phone or a pad with IOS or Android system. The parameters for WIFI
can be set up via a smart-phone or a pad with IOS or Android system, please see section
for more information.
Network connection diagram via wireless network as Figure 2 as an example.
5.3.4 Network--WIFI
2.7 AP
mode
2.7 AP Mode
Flashing
Into AP mode automatically
Into AP mode by manual
Enter the menu “System->Network->Enter AP mode”, choose “Enter AP mode”, it will
automatically reboot and wait for all button LEDs flashing then AP mode is ready.
Note:
1. If the device has went into AP mode, but the wireless function of the device hasn’t been
activation via “uCareHome” on the phone or user doesn’t do any operate about the
device, after 10 minutes the device will automatically exit AP mode and returns to the
previous connection mode.
2. If the monitor is in AP mode, user can through the menu “System->Network->Exit AP
mode” to choose it manually, the monitor will auto reboot and it will exit AP mode.
22
Internet
For factory default parameters, the monitor will into AP mode automatically after power on. After
power on the monitor, if the monitor detects no network, waiting for about 40 seconds all the
button LEDs will be blinking. It indicates the monitor has start in AP mode. Please setup your
WIFI with the “uCareHome” app.
Monitoring
Unlock
Talk
1
2
Hang up
Figure 2
PC
AC/DC power
lock
(not Included)
(not Included)
4C
WIFI(LAN)
IOS/Android
Reset
WAN
LAN
To WAN
AP mode
WIFI
(LAN)
WIFI(LAN)
WIFI(LAN)
1
2
3
3G/4G/WIFI
IOS/Android
IP Indoor Monitor
Modem
Router
AC/DC power
lock
(not Included)
(not Included)
4C
DOOR1
DOOR2
4C
4C
Monitoring
Unlock
Talk
1
2
Hang up
AC/DC power
(not included)
CAM1
AC/DC power
(not included)
CAM2
Figure 1
Internet
Reset
WAN
LAN
AC/DC power
lock
(not Included)
(not Included)
4C
3G/4G/WIFI
IOS/Android
To WAN
To LAN
To LAN
Router
IP Indoor Monitor
Modem
PC
AC/DC power
lock
(not Included)
(not Included)
4C
DOOR1
DOOR2
WIFI(LAN)
IOS/Android
WIFI(LAN)
Monitoring
Unlock
Talk
1
2
Hang up
4C
AC/DC power
(not included)
CAM1
AC/DC power
(not included)
CAM2
4C