USER´S MANUAL BEDIENUNGSANLEITUNG MANUEL D´UTILISATION MANUAL DE USUARIO INSTRUKCJA OBSŁUGI MANUALE D´USO Includes Wireless microphone system Adam Hall GmbH.
CONTENTS ENGLISH PREVENTIVE MEASURES INTRODUCTION CONNECTIONS, OPERATING AND DISPLAY ELEMENTS PIN ALLOCATION FOR MINI XLR CONNECTOR (POCKET TRANSMITTER) TROUBLESHOOTING OPTIONAL ACCESSORIES TECHNICAL DATA MANUFACTURER’S DECLARATIONS 3-4 4-5 5-9 9 10 10-11 11-13 14
ENGLISH YOU‘VE MADE THE RIGHT CHOICE! We have designed this product to operate reliably over many years. LD Systems stands for this with its name and many years of experience as amanufacturer of high-quality audio products.Please read this User‘s Manual carefully,so that you can begin makingoptimum use of your LD Systems product quickly. You can find more information about LD-SYSTEMS at our Internet site WWW.LD-SYSTEMS.COM PREVENTIVE MEASURES 1. Please read these instructions carefully. 2.
CAUTION: Toreduce the riskof electric shock,do not remove cover (or back).There are no user serviceable parts inside.Maintenanceandrepairsshouldbe exclusivelycarriedoutby qualifiedservicepersonnel. The warning triangle with lightning symbol indicates dangerous uninsulated voltage inside the unit, which may cause an electrical shock. The warning triangle with exclamation mark indicates important operating and maintenance instructions. Warning! This symbol indicates a hot surface.
• Available in the following frequencies:470-542MHz (LDU 504.7/LDU 505.1/LDU 305.1/LDU 304.7) Please note: The use of the wireless microphone system may require a license, depending on the country of use. For detailed information please contact the relevant authority in your country. Pilot tone The pilot tone function protects a wireless microphone system against interference, for example, unwanted signals from other radio transmission systems.
4 VOL Rotary knob to adjust the output volume. 5 IR INTERFACE Infra-red interface for synchronising the receiver’s radio channel with the transmitter. 6 ASC Tosynchronisethe transmitterwith the radio channelsetinthe receiver,position theinfra-red portofthe transmitterdirectly inlinewiththe infra-red interface ofthe receiverand switch onthe transmitterandreceiver(distance about10cm,IRinterfaceof the handtransmitteris below the status LED,IR interface of the pocket transmitter on the front side).
14 BALANCED OUTPUT Balanced audio output via 3-pin XLR jack. HAND-HELD TRANSMITTER 15 16 17 18 20 19 15 MICROPHONE HEAD The microphone head is interchangeable, the hand-held transmitter is compatible with the microphone heads from the LD U500® series, available separately. 16 ON / OFF On/off switch. Move the switch to the ON position to turn on the hand-held transmitter, and to the OFF position to turn it off.
2 2 2 2 2 2 2 21 Antenna Pocket transmitter antenna. For optimum reception, do not cover or kink. 22 IR INTERFACE Infra-red interface for synchronising the radio channel from receiver and transmitter. 23 INPUT 3-pin mini XLR socket to connect a headset, Lavalier or instrument microphone and guitar cable. 24 ON / STANDBY / OFF Switch to activate or deactivate the pocket transmitter (ON = transmitter is switched on, OFF = transmitter is switched off).
27 BATTERY COMPARTMENT Toreplace the batteries, open the battery compartment of the pocket transmitter by simultaneously pressing both markers on the sides of the battery cover and opening it forwards. Remove theused batteries and replace with new batteries (AA/LR6,alkaline), following the diagram in the battery compartment. Replace the battery compartment cover on the housing and click it into place.
TROUBLESHOOTING PROBLEM SYMPTOM SOLUTION No audio signal or level too low Receiver: No reception displayed on either antenna A or B. Check if the transmitter is turned on. Check the batteries in the transmitter. Receiver: Display lighting is switched off Checkthepowersupplyforthereceiverandwhether the receiver is switchedon. Receiver: No reception displayed on either antenna A or B. Transmitter: Device is switched on. Charge status of the batteries is ok.
LDU500RK2–19"rackmountingkitfortheinstallationoftwosinglereceivers(2rack-mountbrackets,2connectorsand1setofscrews included). Installation 1. Attach connectors (receiver A on the right-hand side, receiver B on the left-hand side). 2. Screw both receivers together. 3. Attach brackets (receiver A on the left-hand side, receiver B on the right-hand side).
Unbalanced output: 6.3 mm jack 6.3 mm jack Audio output level (balanced): +10dBu +10dBu Audio output level (unbalanced): +7dBV/+2.5dBV (switchable line/instrument) +7dBV/+2.
BODY PACK TRANSMITTER Item number: LDU 305.1 BP/ LDU 304.7 BP LDU 504.7 BP / LDU 505.1 BP Modulation: FM FM Frequency range: 470-542MHz 470-542MHz Channels: 12 24 Input: 3-pin mini-XLR 3-pin mini-XLR (low-Z + phantom power/high-Z) (low-Z + phantom power/high-Z) Frequency response: 25–16,000 Hz 25–16,000 Hz RF output power: 10 mW PEP 0.42 mW PEP Antenna gain: 0.5 dBi 0.
MANUFACTURER´S DECLARATIONS MANUFACTURER‘S WARRANTY & LIMITATIONS OF LIABILITY You can find our current warranty conditions and limitations of liability at: https://cdn-shop.adamhall.com/media/pdf/MANUFACTURERS-DECLARATIONS_LD_SYSTEMS.pdf. To request warranty service for a product, please contact Adam Hall GmbH, Adam-Hall-Str. 1, 61267 Neu Anspach / Email: Info@adamhall.com / +49 (0)6081 / 9419-0.
LD-SYSTEMS.COM Adam Hall GmbH | Adam-Hall-Str. 1 | 61267 Neu-Anspach | Germany Phone: +49 6081 9419-0 | adamhall.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
