Operation Manual

Table Of Contents

VOL

Rotary knob to adjust the output volume.

IR INTERFACE

Infra-red interface for synchronising the receiver’s radio channel with the transmitter.

ASC

Tosynchronisethetransmitterwith theradiochannelsetinthereceiver,positiontheinfra-redportofthetransmitterdirectlyinlinewiththe

infra-redinterfaceofthereceiverandswitchonthetransmitterandreceiver(distance about 10cm,IRinterfaceofthehandtransmitteris

belowthe status LED,IR interface ofthe pocket transmitteron thefront side).Now presstheASC buttonto start thesynchronisationprocess.A

red LED indicator will light upin thewindow of the IR interface during the process.After a few seconds, the process is completed and one of the

LED indicators ANTENNA A and B will light up (= wireless connection exists).

LEVEL INDICATOR

5-segment LED chain to display the audio signal level.

ANTENNA A - B

Indicator LEDs for the antenna systems A and B. The antenna system with the stronger radio signal is activated and the corresponding

indicator LED lights up.

RECEPTION ANTENNAS A - B

For optimum reception, please position the antennas in an upward-facing V-position.

Low-voltage socket for the power supply to the device. Please use only the supplied mains adapter.

CABLE STRAIN-RELIEF

Cable strain relief for power adapter cable.

UNBALANCED OUTPUT

Unbalanced audio output via 6.3mm jack socket.

INSTRUMENT/LINE (UNBALANCED OUTPUT)

Switchfor levelandimpedance-matchingto instruments orlineinputs ofan amplifieror mixer.Using a suitabletool (e.g.aballpoint pen),

push the switch into the depressed INSTRUMENT position for connection to the input of an instrument amplifier (guitar or bass amp) and for

connection to the line-input of a mixer or amplifier, select the non-depressed position LINE.

DC SOCKET