Manual

ITALIANO
POLSKI
ESPAÑOL
FRANCAIS
DEUTSCH
ENGLISH
13
To push the mono signal of the transmitter (INPUT LEFT) into the background, use the button (15 levels: FOC -1, -2, -3, -4, -5, -6, -7,
-8, -9, -A, -b, -C, -d, -E, a max. -F). The volume balance is changed in favour of the audio signal at the right input (INPUT RIGHT) of the
transmitter. In the FOC -0- setting, both input signals of the transmitter are transmitted at the same volume.
To ensure the transmission of a stereo audio signal in the Focus mode, both the transmitter and the receiver have to be in stereo mode
and an audio signal must be present at both INPUT LEFT and RIGHT entrances. When the transmitter is in mono mode, only the (INPUT
RIGHT) audio signal is being transmitted.
SETUP AND TROUBLESHOOTING
SETUP
For optimal transmission, position the transmitter at a minimum height of 1 m and point the antenna upwards. If multiple wireless systems are used
in an installation, please make sure that the antennas do not touch or cross. Do not position the transmitter in the direct vicinity of metal objects
and digitally controlled devices (CD players, computers, digital consoles, etc.). Transmitter and receiver should be within direct “line of sight” of each
other.
TROUBLESHOOTING
PROBLEM DISPLAY SOLUTION
No sound or volume
too low.
Receiver: Display is switched off.
Make certain that the batteries are not dead and
the receiver is on.
Transmitter: Display is switched off.
Check the connection between power supply and
transmitter. Turn on the transmitter.
Receiver: is on, but the RF indicator
is not lit.
Make certain that the transmitter and receiver are
set to the same radio frequency.
Reduce the distance between transmitter and
receiver and make certain that there is a direct
line of sight between transmitter and receiver.
Make certain that the transmitter antenna is
installed correctly.
Receiver: is on and the RF indicator
is lit.
Increase the volume at the receiver and check the
headphone connection.
Check the input level on the transmitter and
increase it if necessary.
Distortion or noise. Receiver: RF indicator is on.
Increase the distance to possible causes of interfe-
rence (digitally controlled devices, e.g., CD players,
computers, digital consoles…).
Use a different radio frequency.
Distorted sound.
Receiver: LOW BATT LED lights up Replace the batteries with new ones.
Transmitter: Level indicator is too high
Lower the volume at the level controls of the
transmitter or at the source device.
Stereo and Focus mode:
Only the right input
signal of the transmitter
is heard, although the
receiver is in the stereo
mode and both inputs of
the transmitter are used.
Transmitter: The transmitter is in the
mono mode.
Switch the transmitter to the stereo mode.
A mono signal is to be
transmitted, but the sig-
nal is only heard on one
side of the headphones.
Transmitter: The transmitter is in the
stereo mode.
Switch the transmitter to the mono mode.
Two mono signals are
to be heard centred in
the headphones, but are
distributed left and right
Switch the receiver to the Focus mode.