User manual

DEUTSCHFRANCAIS

ESPAÑOL

ENGLISH

ITALIANO POLSKI

MINI-XLR

Condenser with internal pull up resistor.

MINI-XLR

2,2k

Condenser without internal pull up resistor.

RECEIVER OPERATION

When operating the wireless transmission system, be sure to place the receiver in the line of sight of the transmitter. For optimal reception,

perform the automatic frequency search after switching on the receiver. Leave the corresponding transmitter off, but other radio systems

turned on, if necessary. For the operating steps, see FREQ AUTO RUN.

DISPLAY

After switching on the receiver, “WELCOME” appears for a short time, then the main screen displays the following information: individual

username, battery status, radio signal level (RF), active antenna (A / B), level of the audio signal, frequency group and channel (GR.xx and

CH.xx) and the radio frequency in MHz.

· Individual username

· Radio signal level and active antenna

· Frequency group and channel

Battery status of the transmitter

· Audio signal level / Peak (PK)

· Radio frequency in MHz

IR SYNC RUN

To synchronize the transmitter with the radio frequency set in the receiver and the individual username, bring the infrared port of the trans-

mitter in direct visual contact with the infrared port of the receiver (distance approx. 10 cm) and turn on the transmitter. Now press the pres-

sure rotary encoder of the receiver (MENU) to access the Edit menu and select the menu item IR SYNC RUN by rotating the encoder (light

background). Press again on MENU to initiate the synchronization process. After a few seconds, the process is completed and the display of

the transmitter switches for a short time to “IR SYNC ”, conﬁrming successful synchronization. To cancel the operation, press MENU. Press

brieﬂy(!) on POWER to return directly to the main display. After about 10 seconds of inactivity, the main display is automatically shown.

FREQ AUTO RUN

Automatic frequency search (frequency scan) to determine an interference-free radio frequency in the current environment and to allow

for optimal reception. For this purpose, leave the corresponding transmitter off, but other radio systems turned on, if necessary. Press the

pressure rotary encoder (MENU) to access the Edit menu and select the menu item FREQ AUTO RUN by rotating the encoder (light back-

ground). To initiate the process, press again on MENU. Progress is now indicated on the display by an animation and the scanning process

is completed after approx. 30 seconds (to cancel, press MENU). The resulting frequency is automatically enabled and, as in “IR SYNC RUN”,

you can now switch on the transmitter and synchronize it with the receiver. Press brieﬂy(!) on POWER to return directly to the main display.

After about 10 seconds of inactivity, the main display is automatically shown.