User's Manual
Table Of Contents
CONFIDENTIAL INFORMATION
This document is the exclusive property of LDL Technology.
No content may be transmitted or reproduced in any form without written permission.
Mounting procedure TCU Ref : C3131320010
Version : A1
Cable management in the TCU neighborhood.
Incorrect wiring will prevent the system from operating properly.
TCU has to be connected to +12V or +24V through 5A fuse protection.
TCU must be connected on Ignition (IGN).
When TCU and ECU or EBS are connected to a same CAN network, they must share the
same ground.
LDL Technology can provide the wiring harness (see table below) :
Nota : This cable has a minimum curvature radius about 80mm.
Reference Description
11 231 0000 Harness CAN (#1-Can)
11 232 0000 Harness (#1)
15 018 0000 Cable TCU CAN 1,2m - Wabco
15 017 0000 Cable TCU CAN 1,2m - EB+ gen3 - Haldex
15 016 0000 Cable TCU CAN Y 1,2m - EB+ gen2 - Haldex
15 015 0000 Cable TCU CAN 1,2m - EB+ gen2 - Haldex
15 014 0000 Cable TCU CAN 1,2m Deutsh 4 contacts 0462-201-16141 - Knorr
15 024 0000 Cable TCU CAN 1,2m – WABCO GIO5
C3131320010-A1-TCU_Mounting_Specification.odt LDL Technology SAS – Toulouse – France 10/ 16
Copyrights 2015