User's Manual

CONFIDENTIAL INFORMATION
This document is the exclusive property of LDL Technology.
No content may be transmitted or reproduced in any form without written permission.
Mounting procedure TCU Ref : C3131320010
Version : A1
LOCKED POSITION OF THE CPA
UNLOCKED POSITION OF THE CPA
TCU harness Delphi APEX 150 Clip holder, IP69K
7. TCU LOCATING RECOMMENDATIONS
The TCU must be fixed horizontally and upside down (connector side facing the ground):
The TCU must be free from any metallic shield in the direction of the connector side.
The antenna should be cleared as possible to optimize RF communication and reduce areas of
non-receipt.
There must be a free area of minimum 5cm wide around the TCU in all directions.
TCU must not be exposed to gritting.
Each TCU must be at a central point between the wheels that it has to receive, and aligned on
the vehicle axis. Distance between TCU and WUS must not exceed 3 meters.
When trailer is equipped with an EBS, TCU bracket should be fixed to EBS bracket.
C3131320010-A1-TCU_Mounting_Specification.odt LDL Technology SAS – Toulouse – France 11/ 16
Copyrights 2015