User's Manual

CONFIDENTIAL INFORMATION
This document is the exclusive property of LDL Technology.
No content may be transmitted or reproduced in any form without written permission.
Mounting procedure TCU Ref : C3131320010
Version : A1
4. TCU MOUNTING INTERFACE.
The TCU is mounted on a plane surface fixed on the vehicle frame. The TCU has 3 mounting
points equipped with silent blocks. The TCU must be fixed on a support (available on demand).
This support (TCU interface) is defined in the appendix.
5. TCU MOUNTING RECOMMENDATIONS
Screws (not provided by LDL) must be tightened @ 4,5 Nm +/-0,5 Nm. It's recommended to use
an elastic washer (Belleville type) between screw head and silent block with spacer. Stainless
steel is recommended.
M6 bolts are recommended, the screw for a fixation on a base plate fixation in thickness 2mm
must have a length equal or higher than 20mm.
C3131320010-A1-TCU_Mounting_Specification.odt LDL Technology SAS – Toulouse – France 7/ 16
Copyrights 2015