User manual

Layout-Light-Control Light-DEC – Manual
- 22 -
11.5. Output function: night function for traffic light pedestrian
and traffic light cross road
If one of the two light-functions traffic-light pedestrian or traffic-light cross-road
has been set as output-function there can be “yellow” flashing individually
activated for a night-function. At night the road light of the traffic light pedestrian
or the road light of the side street will flash yellow.
Via the key ABOVE or BELOW you can switch-on
or off the night function “Yellow flashing”.
After completion of all adjustments within the
menu output-function you have to depress the key
LEFT several times after a warm start until the
operation mode will be indicated at the display:
12. Factory setting
Ex factory are the following values adjusted:
• Start times and Time factors for start adjustment und day phase
• Parameter of the Light-functions which can be changed
The presented values for both issues can be found at tables within the Technical
Manual.
Additionally are output-functions for the first Light-Display-Module (LDM)
preinstalled. Those are listed at the table “Output functions: Factory setting” at the
Technical Manual.
Ex-factory are no switch-times for switch-groups registered. If the factory-setting
will be performed the installed switch times will be deleted.
You can restore the factory-setting. Additionally is there the possibility to waive the
preinstallation of output-functions for the first Light-Display-Module (LDM). In this
case is it not required to delete the single output functions for setting of own
functions.
Depress at first the key RIGHT longer than three seconds. The display will change
into the Main Menu and all light sources will be switched off.
Depress at the Main Menu the key BELOW
shortly several times until the menu Factory
setting will be indicated:
Open now the menu Factory setting with the key
RIGHT.
Night function
>ON<
Light-DEC VX.X
23:30:00 A 300
---Main Menu----
Factory setting
Factory setting
>Examples<