User manual

ManualsBrandsLDT LITTFINSKI DATEN TECHNIK ManualsModel Train ElectronicsLight-DEC-Basis-F

Layout-Light-Control Light-DEC – Manual

- 19 -

11. Output function: assign light functions to the output of

light modules

Via the menu Output functions will be the outputs of the Light-Modules light-

functions and their properties assigned, deleted or changed.

Depress at first the key RIGHT longer than three seconds. The display will change

into the Main Menu and all light sources will be switched off.

Depress at the Main Menu the key BELOW

several times shortly until the Menu step Output

functions will be indicated:

Open now the menu Output functions with the key

RIGHT. The display indicates which Light-Module

has been registered at the position 1:

If you want to assign light functions to the outputs of another Light-Module those

deleting or changing the start options you can select the relative module with the

keys ABOVE or BELOW.

References for the register of Light-Modules can be found at chapter 5.2. of this

Manual. Ex-factory are four Light-Display-Modules (LDM) registered.

With the key RIGHT you can go to the processing of the output functions of the

selected Light-Module.

After first setting into operation are the samples

for the factory settings of the Light-Module 1

active. The display shows the occupancies of the

first 8 clamps with the random light functions

Funfair.

With the keys ABOVE and BELOW can be all established output functions for this

Light-Module indicated.

At the lower line will be the used light-function indicated. At the upper line left side

you will find the position of the Light-Module. Indicated will be as well if it is a Light-

Display- or a Light-Power-Module (LDM or LPM). At the very right you can read the

number of the clamps (outputs), which are occupied by the light-function.

A listing of the output functions for the factory settings can be found at the

Technical Manual at the section “Output function: Factory settings”. Return now

with the keys ABOVE or BELOW to the initial function Random Funfair.

Depress again the key RIGHT for changing the

adjustments for this initial function. At first there

is the possibility to delete the initial function:

We will use this option. With the keys ABOVE or

BELOW you can switch between >NO< and

>YES<. Select >YES<.

---Main Menu----

Output functions

Module pos.: >1<

LDM

1 = LDM-KL:01-08

Random Funfair

Output funktion

Delete: >NO<

Output funktion

Delete: >YES<