User manual

ManualsBrandsLDT LITTFINSKI DATEN TECHNIK ManualsModel Train ElectronicsLight-DEC-Basis-F

Layout-Light-Control Light-DEC – Manual

- 20 -

Depress the key LEFT for deleting the preinstalled

initial functions. Now it will be indicated that the

clamps 1 to 8 will be vacant.

With the key RIGHT you can change to the

possibility to set-up a new light function as initial

function at this clamp section. As a first

possible light function will be always the Railway

crossing initiated:

With the key BELOW can be the available light-functions indicated at the

sequence as they are listed at the Technical Manual under the headline “Description

of the available light functions”.

With the key ABOVE will be the reversal sequence indicated.

If the indicated light-function need more clamps as actual vacant there will come

an Info at the lower line with changing to the name of the light-function the letters

“Not possible”.

Select with the keys ABOVE or BELOW the light-

function ON/OFF. With this light-function will be

the output 1 initiated as switch output e.g. for a

lightsource or a motor.

11.1. Output function: properties always active

Depress now the key RIGHT for selecting the

output function for a property. There are 4

properties available. The display will indicate the

first property:

“Always active” signifies das the output function will be activated as soon as the

day phase function of the Light-control Light-DEC will be started. The output

function will be deactivated if the day phase function will stop.

11.2. Output function: properties switch group

If you want to activate or deactivate timely an output-function during the day phase

via a Switchgroup you have to depress the key ABOVE or BELOW until

>Switchgroup< will be indicated at the display. Now depress the key RIGHT.

If there was no Switchgroup determined for the

output-function before, this will be indicated at

the display with “—“.

If there was already a switch-group determined, this will be indicated at the

display.

Select with the keys ABOVE or BELOW the

suitable Switchgroup. There will be only

Switchgroups for selection indicated for those

switchtimes are released.

During the day phase will be the output-function activated with relation to the

switch times which are selected and released for the relevant Switchgroup as

described within chapter 8 of this manual.

1 = LDM-KL:01-08

**** FREE ****

1 = LDM-KL:01-02

>Railway cross<

1 = LDM-KL:01

>ON / OFF<

Property

>Always active<

Property

Switchgroup:>

Property

Switchgroup:>02<