User manual

Layout-Light-Control Light-DEC – Manual
- 8 -
Do not supply the digital voltage for the Basic-Module directly from the rails.
DCC-Digital systems are using different cable colors or designations for both
digital cables. Mostly used markings are printed next to clamp 5 but do not
necessarily to be used because the Basic-Module will automatically evaluate the
correct DCC-digital signal.
5. First starting-up / selecting language
As soon as the first Light-Module which has been
directly plugged onto the Basic-Module receives
power supply the operation status will be
indicated at the display with a short delay:
If the Display does not correct indicate during first starting-up you should turn with
help of a small screwdriver carefully the potentiometer P1. This Potentiometer is
located at the right side below the display has to be turned halfway left or right until
the information on the display can be optimal read.
For the first 40 light-outputs are output-functions set ex-factory, which will be
started at random within the first 15 seconds after switching-on the unit. If you have
installed some light sources onto the first 40 light outputs those will now lighten
and flash on different intervals.
The starting of the light-functions at random after switching-on provides an
optimal optical impression because multiple installed light functions shall not be
running synchronized.
Within the Technical Manual you can find at the section “Output-Functions /
Factory setting” a table which indicates the assignment of output functions to the
related clamps set ex-factory.
VX.X at the Display of the Operation Display indicates the firmware version of the
Basic-Module. More information about the lower line of the display can be found at
the following pages of this manual.
Below the Display you can find 4 push-buttons indicated with arrows for the
directions LEFT, RIGHT, ABOVE and BELOW. Within the further description those
keys will be indicated as LEFT, RIGHT, ABOVE and BELOW.
The Technical Manual includes a graphical Menu Navigation to illustrate the steps
through the menus parallel to the following descriptions.
Depress now the key RIGHT longer as three
seconds. The display changes into the Main
Menu and all light sources will be switched off:
Ex-factory has been the language “Deutsch” reselected. If you don’t want to
change the language just skip the following lines and carry on reading with chapter
5.1.
If you want to select the language “Deutsch” just
activate the key RIGHT. The display will indicate
the actual selected language:
Light-DEC VX.X
22:30:00 A 300
---Main Menu----
Language
Language
>
English
<