User's Guide

Multi-funcion UV Sterilizer User Guide
Technical Specifications
UV sterilizing power: 2W*2
Type-C input: 9V/2A 5V/2A
USB output:
Wireless output:
Weight: 354g
5V/2A
5V/2A
Sterilize：
Mobile phone, iPod, Mp3 player,
Wireless earphones, Watches,
Keys, Jewelries etc.
What’s in the box
Type-C USB Cable
UV Sterilizer
UV Sterilizer Overview
1
2
3
4
9
5
UV lamp
LED indicators
LED display/Button
USB output port
Type-C input port
6
7
8
Buzzer
Lid
Infrared sensor
Wireless charging
1
2
3
4
6
8
5
7
9
① Plug in Type-C cable, connect UV sterilizer to an
adapter.
② Put your phone inside, press the Button to turn on
the UV lamps.
How to Use
1. UV Sterilizing
Open
③ After 15 minutes, UV lamps automatically turn off,
buzzer will “Beep”, disinfection process completed.
When you open the lid, infrared sensor switch will
detect it, UV lamps will automatically turn off..
When you close the lid, UV lamps will turn on again.
Note:
Close
2. Wireless Charging
Put your phone in UV sterilizer, it will wireless
charge your phone.
1. Wireless charge only supports Qi-enabled phone.
Qi-enabled phone NOT Qi-enabled phone
Note:
2. Quick wireless charge only works with 9V/2A output
adapter (not supplied).
9V/2A
5V/2A 5V/1A
3. Put your phone in the center of UV sterilizer. Please
note wireless charge may not work on phones with
thick case on.
4. If there are metal units between the phone and UV
sanitizer, UV sanitizer will detect them, the green
LED indicator will flash, please take out metal units.
Quick charge
Standard charge
3. USB Charging
Plug in another charging cable, charge other
phones or devices.
Note:
If the output power of adapter is too low, sterilizing,
wireless charging and USB charging will not work
at the same time.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE：
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE：
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement
Warranty certificate
Client’s name :
Contact number :
Username :
Correspondence address:
Email address:
Product information :