Technical Specs
Table Of Contents
- User manual_rev01
- Contents
- Change History
- Table
- Figure
- 1 Introduction
- 2 Technical Specification
- Description
- Items
- 23 ± 0.3 mm
- Length
- 10.2 ± 0.3 mm
- Width
- 2.65 ± 0.3 mm
- Height
- 1.8 g
- Weight
- Description
- Item
- -30 deg. C to +75 deg. C
- Operating temperature range
- -35 deg. C to +75 deg. C
- Storage temperature range
- Up to 95% non-condensing or a wet
- Humidity
- Bulb temperature of +35 deg. C
- 3 Appendix
- 4 Federal Communications Commission (FCC) Statement
- OEM Guidance
© 2016 Leadtek Research Inc. All rights reserved. LEADTEK Confidential Page : 4 / 12
Preliminary Confidential - Information is subject to change without prior notice.
1 Introduction
Leadtek new generation LRBT01H Bluetooth module products
The main unit’s circuitry consists of a device chipset; the nRF52810 Microcontroller Unit and 2.4G RF, the
nRF52810 chip has UART output interface transform .The system is powered by system supply with a
nominal voltage of 3.3V volts.
The nRF52810 Microcontroller is the main processor responsible for driving the RF 2.4GHz signal
communicate and data link to UART interface transform.
Figure 1-1： LR BT01 Image
1.1 Features
1.1.1 Performance
2.4 GHz transceiver
• -96 dBm sensitivity in Bluetooth® low energy mode
• 1 Mbps, 2 Mbps supported data rates
• Single-pin antenna interface
• 5.3 mA peak current in TX (0 dBm)
• 5.4 mA peak current in RX
• RSSI (1 dB resolution)
ARM® Cortex®-M4 32-bit processor with FPU, 64 MHz
• 215 EEMBC CoreMark® score running from flash memory
• 58 μA/MHz running from flash memory
• 51.6 μA/MHz running from RAM
• Data watchpoint and trace (DWT), embedded trace macrocell (ETM), and instrumentation trace
macrocell (ITM)
• Serial wire debug (SWD)
• Trace port
• Flexible power management
• Supply voltage range 2.6 V–3.6 V
• Fully automatic LDO and DC/DC regulator system
• Fast wake-up using 64 MHz internal oscillator