Installation Manual

34 35
To pair the sensor to the hub, press the black button inside the
battery compartment of the LeakSmart Sensor one time.
• When the pairing is successful, the light on top of the sensor
will blink slowly ve times, and you’ll hear three quick beeps.
In the LeakSmart app, watch for the total device count and the
sensor count to each increase by one.
With the sensor successfully paired, replace the battery
compartment door.
To pair additional sensors, repeat steps 1-7.
Tap All My Devices are Paired.
LeakSmart Sensor Setup and Operation LeakSmart Sensor Setup and Operation
6
6a
7
8
9
10
Note: Pairing mode will last for three minutes. If
you don’t successfully pair the sensor(s) before
the three-minute pairing mode ends, you’ll have
to start over at step four.
Black button: to pair the sensor to
the hub, press this button once.
Battery compartment: replace door
once sensor is successfully paired.
Sensor: ve slow ashes from the LED
light and three quick beeps indicate
that the pairing is successful.
6
6a
8