Instruction Manual

3
GETTING STARTED
Initial Setup
1. Plug the USB B Connector end of the Micro USB
Power Cable into the USB B port on the HDMI
Game Stick.
2. Plug the HDMI Game Stick into an HDMI port on
your television.
3. Plug the USB A Connector end of the Micro USB
Power cable into a USB port on your television.
4. Make sure your television is set to display the
same HDMI port that the HDMI Game Stick is
plugged into.
5. Find the battery cover located on the back of the
Wireless Controller, use a screwdriver to loosen
the screw and then open the battery cover.*
6. Remove old batteries by pulling up on one end
of each battery.
7. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries are
recommended.)
8. Replace the battery cover and tighten the screw
to secure.
9. Turn the power switch on the device to On.
* To ensure proper connectivity, install batteries in the device after
the HDMI Game Stick has been plugged into the television.
NOTE
The HDMI Game Stick is only compatible with television sets and is
not compatible with computers or computer monitors.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.