LT-EL138 LED Flashlight
1 ! CAUTION! If you need to mount the flashlight onto a firearm, make sure firearm is not loaded before installation. Remove magazine and examine chamber. Use safe handling procedures at all times. Tactical flashlights produce substantial heat during operation. Do not leave activated flashlight unattended. Do not set activated flashlight face down. Do not place activated flashlight against combustible material or material that could be damaged by heat.
Component Illustration 3 LT-EL138 EL138 (Model Number) AQN0040UB49U (Example Serial Number) T-6 Aircraft Aluminum Main Body Specs Law Enforcement Rated Rolling Stop Shoulder Combat Tactical Front Head (Specific Models Only) Allen Wrench 3mm Velcro Pad for Pressure Switch Pressure Switch (Length: 10” - 25”) LED IRB* Offset Angled Tactical Mount (45° Offset, 30mm Diameter) Accessory Battery Compartment Water Resistant Protective Lens ! Length 116.8mm (4.6”) Main Body Diameter 27.2mm (1.
5 Installation & Operation Fig.1.1 Mounting the Flashlight Battery Installation 1. Unscrew the end cap and install a CR123A lithium battery (Fig.1.1). 2. Replace and tighten the end cap (Fig.1.2). 6 Fig.2.5 Fig.1.2 Fig.3.1 Offset Angled Tactical Flashlight Ring Mount (RG-FL138) 1). Remove the top half of the ring by loosening the screws and 2). Place the flashlight on the ring base (Fig.3.2). slowly backing them out (Fig.3.1). Two Operation Modes 1. Push Button Operation 1).
7 8 Maintenance Replacement Parts Contact your distributor for information: Lithium Battery Pressure Switch 1PC of CR123A Lithium Battery RG-FL138 UTG Offset Angled Low Profile Tactical Flashlight Ring 1. Maintain the metal surface of the flashlight by removing any dirt or sand with a soft brush to avoid scratching the finish. 2. Store the flashlight in a cool dry place when not in use. Be careful to avoid contact with acid, alkaline or corrosive chemicals. 3.
9 10 One Year Limited Warranty Disclaimer and Limitation of Liability This warranty covers defects in materials and workmanship of the product, provided that they are purchased from an authorized distributor and purchased and used in the United States. The warranty lasts for a period of one year from the date of original purchase of the product.