LeapFrog Enterprises, Inc. 6401 Hollis Street, Suite 150 Emeryville, California United States 94608-1070 Tel: 852-2317-2903 Fax: 852-2370-3130 BT4.
Introduction This document describes pin definition, mechanical drawing and reflow data of Bluetooth Low Energy Module and hope it can helps designer to design in easier and manufacturing smoothly. Pin Definition Pin # Pin Name Direction Voltage Desription 1 VDD I 1.8 to 3.3V Input power can range from 1.8V to 3.3V 2 VSS I GND 3 TEST0 I/O 1.8V to 3.3V Mfg Test pin 0; MODE "POINTER". Internally pulled-up (active low) 4 TEST1 I/O 1.8V to 3.3V Mfg Test pin 1; MODE "JOYSTICK".
Mechanical Drawing Reflow data
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 conditions above are met, further transmitter test will not be required.
Industry Canada statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence.
This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate Canada authorization.
Manuel d'information à l'utilisateur final L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué dans ce manuel.
