User Guide

PLA Series Operating Manual
(1). BUS setting page
-33-
A: Channel state;
“Mode”, “name” and “bits in channel” from left to right.
B: Channel/BUS setting zone
C: PORT voltage display
D: Function key
E: State display zone
(2). Channel setting
A: Current state;
This setting is valid only when the channel is BUS.
Bits indicate the quantity of Bit(Channel) in the channel, 1 is single
channel, 0 is shut-off; the others bigger than 1 is BUS.
B: Since "Auto" and "User" modes are valid only when the channel
is BUS, the setting of channel is not affected even if Channel is
displayed by numerical value or selection.