User Guide

PLA Series Operating Manual
-42-
a. In the case of “Low”, “High” and “Don’t Care", press and hold the
left mouse button on the state, then drag leftwards and rightwards to
set rapidly the trigger state.
b. In the case of “Raising” and “Falling”, press and hold the left mouse
button on the state, then drag leftwards and rightwards to shift the
position of “Raising"and "Falling".
* Note: only “Low”, “High” and “Don’t Care" trigger state can be selected
under Pattern2 and Pattern3.
* Either "Raising" or "Falling" can be set under Pattern1 and Pattern OR.
* Under Pattern2 and Pattern3, the next Pattern is compared only when the
setting state of previous Pattern is already achieved. Trigger is effected when
the setting state of all Patterns is met.
* Under Pattern OR mode, Trigger is effected if either Pattern1 or Pattern OR
state is met.