User Guide

PLA Series Operating Manual
A new cursor time display is added onto the tool list by selecting the
starting and ending cursors and then clicking “Add”.
Click the left mouse button on the cursor time to switch between
"cursor time" and "cursor frequency".
-53-
10 . Show the setting of percentage
Click the pull-down on the tool list in the waveform window.
After completion of setting, the position of hollow point will switch
according to the selecting percentage on the picture and proceed the
trigger of the memory by selecting percentage.
After completion of the setting, it will show the percentage of
corresponding use at the left corner.
* After re-catches the data, it will renew status.