User Guide

LA-series Operating Manual
-30-
LA-2050 shortcut ow graph LA-2050 shortcut operation description
Set trigger states of CHs
6. Set trigger state of CHs:
a.Enter into trigger state setting by
pressing “trigger” key.
b.Shift to CHs by shuttle key, the red
position means the setting position.
c. Set by selecting Low, High, X, ,
, where necessary.
d. Exit from setting by pressing F6.
Capture the trigger signal
OK !
7.Capture trigger signal:
a.Turn on the intended test panel or
circuit, press “Run/Stop” to capture
the necessary trigger signal.
b. Alternatively, stop by pressing
"Single" key to capture a single trigger
signal.