User Guide
LA-series Operating Manual
1. Enter into the following channel setting state interface by pressing
After selecting the channels to be modied with shuttle, F1~F6 are
displayed, with the operations described below:
4-3 Setting of Channel Number and Name
-31-
Used to set or change the channel name. The following appears at left lower
part of LCD:
Name: BUS00
↑
Note:
1. BUS00 under Name represents the name of CH0.
2."↑" indicates the character entry position of channel name. After the name
is changed by character key, the remaining characters may be deleted by
pressing "DEL" key. At most 8 characters are used for channel name, along
with English and numerical number.
3. Change the name of CH0 by pressing , and then switch the channel
by shuttle.
4. Exit from the setting by pressing .
: Select ON/OFF of this channel, then press F1 after turning shuttle
to highlight the channel to be adjusted.
: Available with 16 BUS displays, each of which permits 2Channel~16
Channel.
: Numerical value is displayed on waveform, ON or OFF.
: Reorder the channels by CH0~CH31.
: ON/OFF key, if ON is "red", the channel names are displayed, if OFF
is "red", the channel names are not displayed.
: Exit from setting display.