User Guide

LA-series Operating Manual
1. After completion of settings, the capture hook of signal junction box is
linked to the pin of objects.
2. Start to capture the triggered signal waveform after the object is energized.
3. 3 capture modes for trigger signal waveform are available where necessary.
4. Mode 1: press , it indicates it’s intended to capture a single trigger
signal. After capture, the operation is stopped, and the waveform is
displayed on LCD.
4-6 Capture of Trigger Signal
-39-
*”Run” is displayed at right upper corner of LCD, if capture is performed, or
“Stop” is displayed if capture is stopped.
Mode 2: press , "Run" is displayed at right upper corner of LCD, the
rst captured signal waveform will be displayed on LCD, and then replaced
by the second one. Signal capture is stopped press this key again. The last
triggered signal waveform is displayed on LCD.
Mode 3:
Press , "Run" is displayed at right upper corner of LCD, the captured
signal waveform could be automatically stored, and displayed on LCD. In
such case, the captured signal waveform will be continuously overlapped and
displayed on LCD.
Stop the signal capture state by pressing
Press , you can erase the signal waveform automatically stored and
overlapped on LCD, in combination with auto-store key.