User's Manual

LEAR Car2U ™
LEAR Car2U ™ Owner’s Guide Version 3.3 Page 7 12/2/2005
Erasing LEAR Car2U ™ Buttons
Note
The system allows for three devices to be programmed. If you need to change or replace any of
the three devices after it has been initially programmed, it will be necessary to erase the current
settings using the “Erasing LEAR Car2U ™ Buttons” procedure and then reprogram ALL of the
devices being used.
In order to erase either rolling code or fixed code on the LEAR Car2U ™ device, use the
following procedure:
1. Firmly PRESS the two outside LEAR Car2U ™ buttons simultaneously for
approximately twenty seconds until the indicator lights begin to blink rapidly. The
indicator lights are located directly above the buttons.
2. Once the indicator lights begin to blink, RELEASE your fingers from the buttons. The
codes for all buttons (fixed and rolling code) are erased.
FCC and RSS-210 Industry Canada Compliance
If your vehicle is equipped with a LEAR Car2U ™ transmitter, it complies with Part 15 of the
FCC Rules. Operation is subject to two following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may
cause undesired operation.
The LEAR Car2U ™ transmitter complies with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference received including interference that may
cause undesired operation of the device
Changes and modifications to the Lear Car2U ™ transmitter by other than an authorized service
facility could void authorization to use this equipment.
FCC ID: KOBFTE05A
IC: 3521A-FTE05A
Hold down the two outside
buttons simultaneous for twenty
seconds to erase code.