User's Manual

Lear UGDO
Lear UGDO Owner’s Guide Version 3.2 Page 6 3/27/2006
Programming Fixed Code Garage Door Opener or Device
Make sure that your key is ON and engine OFF while programming the transmitter. Use the
following steps to program up to three different devices.
1. To program a fixed code garage door opener you will need the garage door hand-held
transmitter and a paper and pen or pencil. Between 8 and 12 coding switches are revealed
under the battery cover of the hand-held transmitter. Do not change the switch positions.
2. Write down the switch settings from left to right. When a switch is in the Up position,
write “on”, and when a switch is in the Down position write “off”. If a switch is set to a
third position between the Up and Down, write “middle”. An example is shown here.
O
N
12345678
Switch Number 1 2 3 4 5 6 7 8
Switch Position On On Off On Off On Off Off
3. Input these Positions into the Car2U as follows. Simultaneously Press and Release all
three Car2U Buttons to put the device into programming mode.
4. The indicator lights will blink slowly. In order from left to right, and within 2.5
minutes, enter each switch setting into Car2U. Push one Button for each switch as
follows:
 Left Button = “On” switch position
 Right Button = “Off” switch position
 Middle Button = “Middle” switch position