User's Manual

Lear UGDO
Lear UGDO Owner’s Guide Version 3.2 Page 7 3/27/2006
5. After inputting the switch settings, simultaneously Press and Release all 3 Car2U buttons.
The indicator lights will turn on.
6. Press and HOLD the Car2U Button you would like to use to control the garage door. The
indicator light above the selected button should slowly blink. You may need to hold the
button from 5 to 55 seconds.
7. When the garage door moves, immediately release the Button. The indicator light will
blink rapidly until programming is complete.
Press and release the button again. The garage door should move, confirming that
programming is successful and complete.
NOTE
Do not release the button until you see the garage door move. Most garage
doors open quickly. However, some garage doors may take from one to two
and a half minutes to open for the initial garage door opener programming.
Press ANY one of the
three Lear UGDO™
buttons to assign the
fixed code sequence to
the garage door opener.