User's Manual

Figure 5-25
IP Filtering
Data is filtered by IP address. This page enables you to configure the IP address filtering rules.
Enabling IP Filtering
To enable IP Filtering, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set IP Filtering Enable.
3. Click Submit. As shown in Figure 5-26.
Figure 5-26
Disabling IP Filtering
To disable IP Filtering, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set IP Filtering Disable.
3. Click Submit. As shown in Figure 5-27.
Figure 5-27
Setting Allow access network outside the rules
To set allow access network, perform the following steps:
1. Choose Firewall>IP Filtering.
2. Set Allow access network outside the rules.
3. Click Submit. As shown in Figure 5-28.