柳英 2013.5.
B GC
This appliance is intended to be used in households but is not intended to be used in applications such as; – Staff kitchen areas in shops, offices and other working environments; – Farm houses and by clients in hotels, motels and other residential type environments; – Bed and breakfast type environments; consider the location leave your drinks cooler for 2hours Before switching on leave your drinks cooler upright for 2hours to allow the coolant fluid time to settle.
1. Tilt the unit slightly towards the rear and prop it securely. Two people are required to tilt the unit during the door reversal process. 2. Remove the top right hinge cover. 4. Remove the top left screw cover. 5. Remove the screws and bottom hinge. Then remove the adjustable feet from both side. Unscrew 6. Remove the door limiting stopper from The door bottom right to left side. 3. Undo the screws. Then remove the hinge bracket.
7. Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet. 11. Put the hinge cover and the screw cover back. Screw 8. Place the door back on. Ensure the door is aligned horizontally and vertically so that the seals are closed on all sides before finally tightening the top hinge. 9. Insert the hinge bracket and screw it to the top of the unit. 10. Use a spanner to tighten it if necessary. 12.
Plug in and switch on Temperature controls The drinks cooler runs on an electricity supply of 220-240V 50Hz and must be earthed. temperature setting Plug in the drinks cooler and switch it on at the socket. Your drinks cooler is factory set to provide your drinks with an optimum environment for storage and longevity. To turn your drinks cooler off,simply switch it off at the socket. The thermostat is located on the unit step,inside the cabinet at the rear bottom.
Changing the internal light Glass door condensation DF72G only. From time to time, depending on the extenal temperature and humidity level, some condensation may appear on the glass door. This phenomenon has no effect on the product and will disappear when the difference between the external and internal temperature is reduced. Before carrying out the bulb replacement always switch off and disconnect the electricity supply.
Cleaning your drinks cooler Defrosting your drinks cooler on the outside Your drinks cooler automatically defrosts regularly, every time it finishes a cooling cycle. The defrost water will collect in the trough, located at the back of the cooler. It is important to keep the defrost drain (the small hole in the middle of the trough) clear, otherwise defrost water will overflow onto the inside floor of the cooler.
Stoney Lane,Prescot,Merseyside L35 2XW Tel:0844 815 3737
Useful hints Safety If your appliance is to be out of service for any length of time ensure that the interior is carefully cleaned and dried. Leave the door open and disconnect the plug from the mains socket. Ensure that the appliance is earthed. Ensure that the appliance is disconnected from the mains supply before atten covers (if fitted). Ensure that the appliance is disconnected from the mains supply before cleaning internally or defrosting.
Disposal Your cabinet is CFC and HCFC free and therefore has no ozone depletion potential (zero ODP). However, all refrigeration appliances should be disposed of in a responsible manner. Ensure that none of the pipes on the back of the appliance are damaged prior to disposal. Up to date information concerning options for disposing of your old appliance and packaging from your new appliance can be obtained from your retailer or local council office.
Telephone:0844 815 3737 Stoney Lane,Prescot,Merseyside L35 2XW www.lec.co.
Lec Guarantee Your Lec drinks cooler is made from the very best materials to the highest standards of manufacture and has been extensively tested and inspected before leaving our factory. It conforms with current British and European Electrical Safety Standards. It is guaranteed for one year from the date of purchase, against mechabical and material defects, with the exception of light bulbs.
