User manual

ManualsBrandsLECROY ManualsTest Leads & ProbesProbe Scoop-proof 500 MHz 10:1 600 V

Probe PP006A

The PP006A is a high impedance passive probe with a wide range of probing accessories. It

is designed to give high impedance probing capability to a circuit when attached to a LeCroy

Oscilloscope.

System BW (－3dB) : 500 MHz

System Attenuation : 10×±2%

System Input Resistance : 10 M (Ω) // 12 pF

Compensation Range : 13 pF to 23 pF

Cable Length : 1.2 meters, Connector type BNC

Max. non-destructive input voltage : 600 V (DC + Peak AC) (see derating curve)

Probe Sense : Yes

ccessories Table

Item PP006A

PK116 accessory

package

① Sprung hook 1 1

② Ground lead (11 cm) 1 1

③ Ground lead on probe tip 1 1

④ IC Insulating tip 1 1

⑤ Color marking band (yellow, red, blue, green) 4×2 4×2

⑥ Trimmer tool 1 1

Summary of content (4 pages)

PAGE 1
Probe PP006A The PP006A is a high impedance passive probe with a wide range of probing accessories. It is designed to give high impedance probing capability to a circuit when attached to a LeCroy Oscilloscope. System BW (－3dB) System Attenuation System Input Resistance Compensation Range Cable Length Max. non-destructive input voltage Probe Sense : : : : : : : 500 MHz 10×±2% 10 M (Ω) // 12 pF 13 pF to 23 pF 1.
PAGE 2
Probe Adjustment LF Adjustment LF compensation is made by connecting the probe to the cal signal and adjusting the compensation trimmer in the BNC-box at end of the probe. Connect the BNC end of the probe to a channel of the oscilloscope. Connect the sprung hook end (1) and the ground lead (2) to the CAL out and GND on the scope Calibrator area. The CAL signal is available in many speeds. Select the Utilities in the scope to set the CAL to 1 kHz. Turn the scope channel on.
PAGE 3
Installation for Safe and Efficient Operation Operating Environment Before using the Probe, ensure that its operating environment will be maintained within these parameters : Operation : In-door Use Temperature : 5 to 40 oC or 41 to 104 oF Humidity : < 80 % RH (non-condensing) The Probe has been designed to comply with EN61010-1 Installation (Overvoltage) Category II, 600 V, Pollution Degree 2.
PAGE 4
Cleaning and Maintenance The exterior of the probe and cable should only be cleaned using a soft cloth moistened with water or isopropyl alcohol. The use of abrasive agents, strong detergents, or other solvents may damage the probe. Assure that the input receptacles are free of debris before inserting connection accessories. All repair and maintenance should be referred to qualified service personnel. Do not use the probe if any part is damaged.