Information

Teledyne LeCroy WaveAce Integration with LogicStudio page | 5 of 10
Configuring the WaveAce, LogicStudio, and PC hardware requires three interconnections:
1. A coaxial-cable connection between the WaveAce’s front-panel EXT TRIG input and LogicStudio’s TRIG
OUT jack.
2. USB connections between the WaveAce and the PC and between the LogicStudio and the PC.
Once these connections are established, open the LogicStudio software and turn on the WaveAce. A
Device Finder wizard, shown in Figure 3, is found at the upper left-hand corner of the GUI or in the
Devices menu. Click on the top center button in the wizard, which denotes a logic analyzer being added
to an oscilloscope. Then highlight the LogicStudio and WaveAce listings and click Next.
Figure 3: LogicStudio’s Device Finder wizard facilitates USB connection of the
LogicStudio logic-analyzer module and the WaveAce oscilloscope to the PC