User manual

Operator's Manual
94 WA1K2K-OM-E RevB
Note: Turning Enable Test On/Off allows you to control whether or
not the mask is shown on the display grid area while making your
settings. The Operate button runs the test and allows you to see the
results update in real time.
2. Press the Source option button and select a source (CHS 1 - 2; or
CHS 1 - 4 on 4 channel models).
3. Use the Operate option button to run and stop the Pass/Fail test.
4. Press the Msg Display option button to turn message display
On/Off during the Pass/Fail test.
Pass/Fail - Page 2/2
After pressing Next Page from Page 1/2, the second of two PASS/FAIL
menus (Page 2/2) is shown and contains the following option button
controls.
1. Press the Output option button to either Pass or Fail.
2. Press the Stop On Output option button and turn it On/Off as
desired.
3. Use the Mask Setting option button to show the Mask menu Page
1/2.
Mask - Page 1/2
Mask Page 1/2 contains the following option button controls.