User's Manual

DPR-A
LECTROSONICS, INC.
20
Specifications and Features
For body worn operation, this transmitter model has
been tested and meets the FCC RF exposure guidelines
when used with the Lectrosonics accessories supplied or
designated for this product. Use of other accessories may
not ensure compliance with FCC RF exposure guidelines.
Contact Lectrosonics if you have any questions or need
more information about RF exposure using this product..
This device complies with FCC radiation exposure limits as
set forth for an uncontrolled environment. This device should
be installed and operated so that its antenna(s) are not co-
located or operating in conjunction with any other antenna
or transmitter.
Transmitter
Operating Frequencies: US: 470.100 - 607.950 MHz
Frequency Selection Steps: 25 kHz
RF Power output: Selectable 25/50 mW
Frequency stability: ± 0.002%
Digital modulation: 8PSK
Spurious radiation: Compliant with
ETSI EN 300 422-1 v1.4.2
Equivalent input noise: –125 dBV
(A-weighted)
Input level: Nominal 2 mV to 300 mV,
before limiting
Greater than 1V maximum, with limiting
Input impedance: 1K Ohm
Input limiter: Dual envelope type; 30 dB range
Gain control range: 55 dB in 1 dB steps; digital control
Modulation indicators: • Dual bi-color LEDs indicate
modulation of -20, -10, 0, +10 dB
referenced to full modulation
• LCD bar graph
Encryption: AES 256-CTR
(per FIPS 197 and FIPS 140-2)
Audio Performance:
Frequency Response: 25 Hz to 20 kHz, (+0, -3dB)
Low frequency Roll-off: Adjustable for -3dB @ 25, 35, 50, 70,
100, 120 and 150 Hz
Input Dynamic Range: 110 dB (A), before limiting
125 dB (with full Tx limiting)
Controls & Indicators: • LCD w/membrane switches
• LED audio level indicators
Audio Input Jack: Standard 3-pin XLR (female)
Phantom Power: 5V @ 18 mA max., 15V @ 15 mA max.
and 48 V @ 4 mA max., plus “OFF”
IR (infrared) port: For quick setup by transferring settings
from an IR enabled receiver
Antenna: External SMA antenna jack
Battery: Two 1.5 Volt AA (lithium recommended)
Battery Life: AA Lithium, 48v phantom power
engaged:
• SCHOEPS CMIT 5U: 7h 25m
• SCHOEPS CMC6-U/MK41: 7h 20m
• SANKEN CS-1: 8h 0m
Weight: 7.8 ozs. (221 grams)
Dimensions: 4.21” L [excluding antenna: DPR-A] x
1.62” W x 1.38” H
(106.9 L x 41.1W x 35.0 H mm)
Emission Designator: 170KG1E
Recorder
Storage media: microSDHC memory card (HC Type)
File format: .wav files (BWF)
A/D converter: 24-bit
Sampling rate: 48 kHz
Recording modes/Bit rate: HD mono: 24 bit - 144 kb/s
Input:
Type: Analog mic/line level compatible; servo bias
preamp for 2V and 4V lavaliere microphones
Input level: • Dynamic mic: 0.5 mV to 50 mV
• Electret mic: Nominal 2 mV to 300 mV
• Line level: 17 mV to 1.7 V
Input connector: TA5M 5-pin male
Timecode:
Connector: 3.5 mm TRS
Signal voltage: 0.5 Vp-p to 5 Vp-p
Input impedance: 10 k Ohms
Format: SMPTE 12M - 1999 compliant
Audio Performance:
Frequency response: 25 Hz to 20 kHz; +0.5/-1.5 dB
Dynamic range: 110 dB (A), before limiting
125 dB (with full Tx limiting)
Distortion: < 0.035%
Operating temperature range:
Celsius: -20 to 50
Fahrenheit: -5 to 122