User's Manual

Digital Receiver

Rio Rancho, NM

Tensioning lock

nuts on the rear

side of the bracket

6. Install one side of the front tie bracket (Part #25991)

into the side panel opening in one of the receivers.

Insert the screws, but do not tighten them com-

pletely at this point.

Slide the other receiver over the tie bracket and in-

sert the screws, but do not tighten them completely

until the rear tie bracket is installed.

Rear tie bracket

(Part #25990)

Front tie bracket

(Part #25991)

7. Remove the four cap screws from the adjacent rear

panels, and then use them to attach the rear tie

bracket. Do not tighten the screws completely.

8. After front and rear tie brackets are installed, place

the receivers on a ﬂat surface so the that the front

panels are even with each other. Hold the receivers

in place and tighten all cap screws on the front and

rear brackets.

NOTE: If the supplied rubber feet are installed on

under side of DSQD, it will not ﬁt in a rack unless

there is an empty space below it.