User's Manual

Digital Hybrid Wireless Belt-Pack Transmitter
Rio Rancho, NM
7
Powering On in Standby Mode
A brief press of the Power Button , releasing it before
the counter has reached 3, will turn the unit on with the
RF output turned off. In this Standby Mode, the menus
can be browsed to make settings and adjustments with-
out the risk of interfering with other wireless systems
nearby.
Hold
for
Rf On
...1
Release Power
Button before
the counter
reaches 3 to
enter standby
mode
5
494.500
-40
-20
0
1
b 19
RF indicator blinks
After settings and adjustments are made, press the
power button again to turn the unit off.
NOTE: Also see the section entitled Power Menu
for the AutoOn feature.
Powering Off
Powering
O . . .
1
From any screen, power can be
turned off by selecting Pwr Off in the
power menu or holding the Power
Button in and waiting for the
countdown, EXCEPT if the top panel
switch is configured for this function.
If the power button is released, or
the top panel switch is turned back on again before the
countdown is completed, the unit will remain turned on
and the LCD will return to the same screen or menu
that was displayed previously.
NOTE: When the top panel switch is configured as
a power switch, that is the only way to turn the unit
off.
Navigating Menus
The LCD and keypad interface make it easy to browse
the menus and make the selections for the setup the
user needs. When the unit is powered up in either the
operating or the standby mode, press MENU/SEL on
the keypad to enter a menu structure on the LCD. Use
the and arrow buttons to select the menu item.
Then press the MENU/SEL button to enter the menu.
The prompt in the upper right corner may
display one or both arrows, depending upon
what adjustment can be made. If the changes
are locked, a small padlock symbol will appear.
Gain
Freq.
ProgSw
Compat
-40
-20
0
Gain
25
Locking/Unlocking Changes to Settings
Changes to the settings can be locked.
StepSiz
Phase
Locked
Backlit
Locked?
No
Ye s
-40
-20
0
Gain
25
A small padlock symbol will appear on adjustment
screens when changes have been locked.
When changes are locked, several controls and actions
can still be used:
• Settings can still be unlocked
• Menus can still be browsed
• Programmable switch still works
• Power can still be turned off by using the power
menu or removing the batteries.
Power Menu
Pressing the power button when the unit is turned on
will display a menu with several options:
• Resume - returns to the previous mode and screen
• Pwr Off - turns the unit off irrevocably
• Rf On? - enters a screen to enable the operating or
standby modes
• AutoOn? - allows the unit to automatically turn
back on after a power failure or when fresh batter-
ies are installed (works in the operating mode only)
• Backlit - adjusts the duration of the LCD back light
to 30 seconds or 5 minutes, or to remain on
• LED Off - turns the LEDs on (Normal) or off (Dark)
• About - displays the installed firmware version.