User's Manual

Digital Hybrid Wireless Belt-Pack Transmitter
Rio Rancho, NM
11
PWR/FUNC
-10
-20
AUDIO
494.500
b 19
MUTE
<–MUTE–>
51
Main Window will blink
the word MUTE when
the audio is muted
Top Panel LED will
blink blue when the
audio is muted
If the programmable switch function is set for Talkback,
the Main Window will indicate that the function is en-
abled but not active.
494.500
-40
-20
0
b 19
TB
51
Talkback
function is
enabled but
not active
When the programmable switch is turned on, the talk-
back icon appearance will change and the power/func-
tion LED will glow blue.
PWR/FUNC
-10
-20
AUDIO
494.500
-40
-20
0
b 19
TB
51
The TB icon will
change when
Talkback is active
Top Panel LED will
glow blue when
Talkback is active
Selecting the Compatibility (Compat) Mode
When used with a Lectrosonics Digital Hybrid Wireless
®
receiver, the best audio quality will be achieved with the
system set to the Nu Hybrid compatibility mode.
Rolloff
Compat
StepSiz
Phase
Compat
Nu Hybrid
Use the UP and DOWN arrows to select the desired
mode, then press the BACK button twice to return to the
Main Window.
Compatibility modes are as follows:
Receiver Models
• Nu Hybrid
• IFB
• Mode 3
NOTE: If your Lectrosonics receiver does not have
Nu Hybrid mode, set the receiver to Euro Digital
Hybrid Wireless® (EU Dig. Hybrid).
Connecting the Signal Source
Microphones, line level audio sources and instruments
can be used with the transmitter. Refer to the section
entitled Wiring Hookups for Different Sources for
details on the correct wiring for line level sources and
microphones to take full advantage of the Servo Bias
circuitry.
Using Line Level and Instrument Inputs
Two types of high levels signals can be used with the
transmitter:
• Line Used with line level outputs from recorders,
mixers and other audio devices.
• Instr. (instrument) A special type of high imped-
ance input with an active preamp for an
optimal match with instrument pickups.
Gain
LineIn
Freq.
ProgSw
LineIn
Line
Instr.
LineIn
Line
Instr.
The wiring of the connector is the same for both types
of inputs.
Selecting the Low Frequency Roll-off
Low frequency audio content may be desirable or
distracting, so the point at which the roll-off takes place
can be set to 35, 50, 70, 100, 120 and 150 Hz.
Rolloff
70 Hz
Rolloff
Compat
StepSiz
Phase