User's Manual

ManualsBrandsLectrosonics ManualsPro AudioSRc Dual-Channel Slot-Mount ENG Receiver

SRc5P and SRc Dual Receivers

LECTROSONICS, INC.

LCD Main Window

The Main Window displays information concerning the

condition of the Pilot Tone, antenna phase, RF and

audio signal levels and battery conditions for both the

receiver and the associated transmitter.

Pressing the MENU/SEL button accesses the menus

and screens for setting up the receiver and searching

for clear frequency channels.

Pilot Tone Indicator

A steady “P” icon will be displayed when a pilot tone from the transmitter is present. The “P” will ap-

pear only in those compatibility modes which use pilot tone, such as the native Digital Hybrid, 200 Se-

ries, IFB modes and Mode 6. The icon will ﬂash if no pilot tone is detected and will change to a small

“b” if the pilot tone has been bypassed. To bypass or enable the pilot tone on Receiver 1, hold MENU/

SEL button and press the UP button brieﬂy. To bypass or enable the pilot tone on Receiver 2, hold

MENU/SEL and press the DOWN button brieﬂy. Bypassing the pilot tone also disables the squelch,

regardless of which compatibility mode has been selected.

Channel Mute

The audio output can be muted on Receiver 1 by holding the MENU/SEL button and holding the UP

button for about a second or more. Receiver 2 can be muted by holding MENU/SEL and then hold-

ing the DOWN button. The same buttons toggle the mute status off. An “M” will appear on the screen

when a channel is muted. In ratio diversity mode, the UP button is used and a signal M appears.

Antenna Phase Indicator

This antenna icon is displayed when the SWITCHING DIVERSITY mode is selected. As the antenna

phase is switched, the symbol will ﬂip vertically.

RF Level

This icon changes in size vertically to indicate the strength of the incoming RF signal.

Audio Levels

One icon is used in the SWITCHED DIVERSITY mode and the other when RATIO DIVERSITY is

selected. The icon changes in size horizontally to indicate the audio level (modulation) of the signal

received from the transmitter. The icon display will change to a solid rectangular block when the audio

signal is being limited in the transmitter.

Battery Levels

When the COMPAT mode is set for a compatibility mode that supports battery telemetry (Digital

Hybrid and 200 Series), a battery icon is displayed on the LCD to indicate the transmitter battery

condition. The receiver will periodically check the battery voltage and update the icon in a “fuel gauge”

manner. In the example at left, the icon indicates about “half full.” When other COMPAT modes are

selected, this area of the LCD will be blank.

If selected in the TXBAT setup screen, a transmitter battery timer is available for any compatibility

mode. It accumulates hours and minutes whenever the transmitter is turned on, and retains the ac-

cumulated time even when the receiver is off. The icon represents a digital clock readout (rotated 90

degrees clockwise) and in this example is indicating 4 minutes. To reset the battery timer, change

the selection in TXBAT to something other than a timer mode, then back to the desired mode.

Icon

Description

NOTE: When the RATIO DIVERSITY mode is

selected, both receivers are combined to pick up

the same transmitter, so the Main Window will

display a single audio channel.

Receiver 1

RF Level

Receiver 2

RF Level

Audio

Level

Transmitter

Battery Level

RF Levels Audio Level

Transmitter

Battery Level

Pilot Tone

Indicator

Receiver 1 Receiver 2

Diversity

Activity