User's Manual

Micro Body Pack Transmitter
Rio Rancho, NM
3
Consumer Alert for US Users - FCC Order DA 10-92
Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this micro-
phone system without a license is subject to certain restrictions: the system may not cause harmful interference; it
must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received
from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless mi-
crophone systems, and these rules are subject to change. For more information, call the FCC at 1-888- CALL-FCC
(TTY: 1-888-TELL-FCC) or visit the FCC’s wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones.
To operate wireless microphone systems at power greater than 50mW, you must qualify as a Part 74 user and be
licensed. If you qualify and wish to apply for a license go to: http://www.fcc.gov/Forms/Form601/601.html
Table of Contents
Introduction ..............................................................................4
Three Block Tuning Range .....................................................4
About Frequency Blocks ........................................................4
About Digital Hybrid Wireless
®
...............................................4
Battery Charging .....................................................................5
Battery Installation ..................................................................5
Controls and Functions ..........................................................6
Modulation LEDs ....................................................................6
LCD Screen ...........................................................................6
BATT LED ..............................................................................6
AUDIO Button ........................................................................6
FREQ Button ..........................................................................6
Power Button ..........................................................................6
UP and DOWN Arrow Buttons ...............................................6
Connectors and USB Port ......................................................7
Attaching and Removing the Microphone .............................7
Operating Instructions ............................................................8
Powering On in Operating Mode ............................................8
Powering On in Standby Mode ..............................................8
Powering Off ..........................................................................8
Setup Screens .......................................................................8
Screens Used in Normal Operation .......................................8
Setup Steps ...........................................................................8
Setup Screens ..........................................................................9
DOWN Button Menu ..............................................................9
UP Button Menu .....................................................................9
Adjusting the Input Gain .......................................................10
Input Jack Configuration ......................................................10
Locking the Controls ............................................................. 10
Remote Control ......................................................................10
IR (infrared) Sync ...................................................................11
Removable Belt Clip ..............................................................11
Accessories ...........................................................................12
Specifications ........................................................................13
Service and Repair ................................................................14
Returning Units for Repair ...................................................14
FCC Notices:
For body worn operation, this transmitter model has been tested and meets the FCC RF exposure
guidelines when used with the Lectrosonics accessories supplied or designated for this product.
Use of other accessories may not ensure compliance with FCC RF exposure guidelines. Contact
Lectrosonics if you have any questions or need more information about RF exposure using this
product..
This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment.
This device should be installed and operated so that its antenna(s) are not co-located or operating in
conjunction with any other antenna or transmitter.
Industry Canada Notices:
Per RSS-210
This device operates on a no-protection no-interference basis. Should the user seek to obtain
protection from other radio services operating in the same TV bands, a radio licence is required.
Please consult Industry Canada’s document CPC-2-1-28, Optional Licensing for Low-Power Radio
Apparatus in the TV Bands, for details.
Per RSS-Gen
This device complies with Industry Canada’s lecence-exempt RSSs. Operation is subject to the
following two conditions:
1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.