User's Manual

Micro Body Pack Transmitter

Rio Rancho, NM

Setup Screens

DOWN Button Menu

Hold the DOWN button while powering up the unit. Then press the AUDIO button repeatedly to scroll through the

following settings. Use the UP and DOWN arrows to select the available options under each setting.

 • rc - remote control operation; selections: on, oFF

 • PbAc - power-back-on after power loss; selections: 0 (stay turned off), 1 (turn back on)

 • bL - back light duration; selections: 5 (minutes), 30 (seconds), on (always on)

UP Button Menu

Hold the UP button while powering up the unit. Then press the AUDIO button repeatedly to scroll through and se-

lect the following settings (bulleted). Use the UP and DOWN arrows to select the available options under each setting.

 • CP - compatibility mode; press the UP and DOWN arrows to select one of the following:

CP 400 400 Series (Digital Hybrid) mode

CP 3 Mode 3 (contact the factory for details)

CP 200 200 Series mode; receivers such as UCR200/201/205D/210/211

CP 100 100 Series mode; UCR100 receiver

CP 7 Mode 7 (contact the factory for details)

CP 6 Mode 6 (contact the factory for details)

CP IFb IFB Series mode; IFBR1/1a receivers

 • Pr - RF power output; selections: 25, 50

 • In - Input conﬁguration; press the UP and DOWN arrows to select one of the following:

In dYn no bias, lo-Z; use for dynamic microphones

In CoS 4v bias, lo-Z; phase reversed; use for Sanken COS-11, M152 and similar mics

In b6 2v bias, lo-Z; use for Countryman B6 and similar mics

In dPA 4v bias, mid-Z; use for DPA lavaliere and similar mics

In L In no bias, hi-Z; use for line level input

In otH 4v bias, lo-Z; same as CoS but audio phase is not reversed; for various mics

In SEt Press the AUDIO button for manual setup of input for explicit control over bias voltage, input

resistance and audio polarity. Press the AUDIO button to select the following

parameters, then use the UP and DOWN arrows for each item to set the values.

bIAS - bias voltage on the input; selections 0, 2 or 4

rES - input impedance; selections: 0 (300 ohms), Lo (approx. 4 k ohms) or HI (approx. 100 k ohms)

AP - audio polarity (aka “phase”); selections: P for positive, n for negative (reversed)

NOTE: When you press AUDIO after setting the polarity, the screen will leave this submenu and return

to the In menu. To return to this submenu, press AUDIO repeatedly and scroll through the list again.

StP Frequency tuning step size in kHz; selections: 25 kHz or 100 kHz