Installation Guide

LED Wall Pack Light Instruction
Application：
Available in tunnel (except for motor vehicle tunnel), workshop, warehouse,
factory, house, building exterior, etc.
Caution：
1. Can not use the electric generator to test the LED lamp;
2. Please abide by related country, regional and local law and regulations when
install this fixture;
3. Please don't install the fixture when raining to lower the risk of electric shock
and avoid the failure.
Note：
1. To avoid possibility of electrical shock or fire, the installation personnel must
have professional electric knowledge;
2. Please wear gloves to avoid injury before installation;
3. If any smoke or spark of the wire happened, please turn off the power
immediately and notify relevant personnel;
4. This fixture is available in outdoor usage, but the distance from fixture to
ground should be more than 2m.
The installation of the product can be used when it is marked
with "√ ".
Installation I:
1. Take out the light, and loosen the screws on the cover and take apart the fixture
by the screwdriver. Pull off the quick connect terminal vigorously. (Figure1,A&B)
This installation instruction applies to the following products. Although the products
vary in appearance, their installation steps are the same:
LES FILS D’ALIMENTATION 75 °C MIN
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE
CODE D'INSTALLATION PERTINENT, PAR UNE PERSONNE
QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT
AINSI QUE LES RISQUES INHÉRENTS.
Warning/Avertissement:
MIN 75 °C SUPPLY CONDUCTOR
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH
THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED.
Standard wire:
L/live wire: Black\Brown;
N/null wire: White\Blue;
Ground wire: Green\Yellow-green.
6. Caution: When the product is installed, pls remove the plug at the drain hole.
(Figure. 6)
5. Connect the quick connect terminal, then screw the fixture bottom plate
(
Figure 5, A&B)
7. Please subiect to the installation steps according to the actual products purchased.
Follow the below addtional installation steps if the product is equipped with areflector
(Take the SWP01 series for example).
When metal reflector is equipped, pls lock it on the luminaire with screws.(Figure 7)
Figure 1, A
Figure 5, A
Figure 5, B
Figure 6
Figure 7
WP03、04 (35-120W)
WP04 (100-120W)
SWP01 (35-120W)
FWP01 (40-80W)
FWP01 (100-150W)
Figure 1, B
Warning: During grounding, make sure the earth wire of the drive and lam
housing are connected together with the earth wire of the local power supply.
Rev: A2
CAUTION: When the lamp is installed,
pls remove the plug!!!