Installation Guide
3. Loosen the plug on the bottom plate, then put the wiring through the hole,
screw the bottom cover with junction box on the wall.(Figure 3, A&B)
4. Make wiring connections per “Electrical Connections” section and make sure
the good wire protection.(Figure 4)
5. Connect the quick connect terminal, then screw the fixture with bottom plate.
(Figure 3, A&B)
6. Caution: When the product is installed, pls remove the plug at the drain hole.
(Figure 6)
2. Drill an installation holes at the bottle of light, paste the EVA mat. (Figure 2, A&B)
1. Take out the light, and loosen the screws on the cover and take apart the fixture
by the screwdriver. Pull off the quick connect terminal vigorously. (Figure1,A&B)
2. Choose an appropriate connoction hole according to your requirements. Loosen
the plug, and then fie the waterproof connector from the accessories; rotate the
three mounting kits to the proper angle . (Figure2)
Installation II:
3. Put the fixture on the wall, make three marks according to the three mounting kits,
then drill three holes for them. (Figure3, A)
Get rubber plugs into the holes, match the three mounting kits to the rubber
plugs, then fix the fixture on the wall by screws with the spring washer and
plain cushion. (Figure3, B&C)
4. After installing the bottom plate, pull the outside wiring into the fixture by the
waterproof connector, and tighten the screws on the connector. Make wiring
connections per “Electrical Connections” section and make sure the good wire
protection. (Figure 4)
7. Please subiect to the installation steps according to the actual products purchased.
Follow the below addtional installation steps if the product is equipped with areflector
(Take the SWP01 series for example).
When metal reflector is equipped, pls lock it on the luminaire with screws.(Figure 7)
Figure 2, A Figure 2, B
Figure 3, A
Figure 5, A Figure 5, B
Figure 6
Figure 1, A Figure 1, B
Figure 2
Figure 3, A Figure 3, B Figure 3, C
Figure 3, B Figure 4
CAUTION: When the lamp is installed,
pls remove the plug!!!