Datasheet

www.i-led.co.uk
Intelligent LED Solutions,Unit 2, Berkshire Business Centre, Berkshire Drive, Thatcham, Berkshire, RG19 4EW
Telephone : [phone] Fax : [phone] Email: [e-mail] www.i-led.co.uk
A division of Intelligent Group Solutions Ltd
2
© IGS Version V2.1 March 2017
Important Information and Precautions
z The PowerStar’s LED, when powered up, is very bright. Thus it is advised that you do not look directly at it. Turn the
PowerStar away from you and do not shine into the eyes of others.
z PowerStars will overheat in operation if not attached to a suitable Heat Sink. Over heating can cause failure or
irreparable damage.
z Do not operate PowerStars with a Power Supply with unlimited current. Connection to constant voltage Power
Supplies that are not current limited may cause the PowerStar to consume current above the specified maximum and
cause failure or irreparable damage.
z PowerStars, when operated, can reach high temperatures thus there is risk of injury if they are touched.
z DO NOT HOT PLUG ON LED SIDE OF POWER SUPPLY.
Product Options
ILS PART NUMBER Colour Dominant
Wavelength*
TypicalWattage § Forward
Voltage
Flux † at
350mA
Radiance
Angle
Relevant
OSRAM LED
Data
at 350mA at 700mA
ILH-ON04-DEBL-SC211-WIR200. Deep Blue 455nm 4.34 watts 8.68 watts 10.80 to 14.0 volts <2520 mW 80˚ (± 40˚) LDCQ7P
ILH-ON04-SIBL-SC211-WIR200. Signal Blue 470nm 4.34 watts 8.68 watts 10.80 to 14.0 volts < 284 lm 80˚ (± 40˚) LBCL7P
ILH-ON04-TRGR-SC211-WIR200. True Green 528nm 4.34 watts 8.68 watts 10.80 to 14.0 volts < 448 lm 80˚ (± 40˚) LTCP7P
ILH-ON04-YELL-SC211-WIR200. Yellow 590nm 3.24 watts 6.44 watts 8.00 to 10.40 volts < 284 lm 80˚ (± 40˚) LYCP7P
ILH-ON04-RDOR-SC211-WIR200. Red-Orange 617nm 3.08 watts 9.24 watts 8.00 to 10.40 volts < 360 lm 80˚ (± 40˚) LACP7P
ILH-ON04-RED1-SC211-WIR200. Red 625nm 3.64 watts 7.28 watts 8.00 to 10.40 volts < 284 lm 80˚ (± 40˚) LRCP7P
ILH-ON04-HYRE-SC211-WIR200. Hyper Red 656nm 3.00 watts 5.88 watts 8.00 to 10.40 volts < 1600 lm 80˚ (± 40˚) LHCP7P
ILH-ON04-FRED-SC211-WIR200. Far Red 730nm 2.6 watts 5.2 watts 6.4 to 9.2 volts >804mW 80˚(±40˚) GFCS8PM1.24
*Due to the special conditions of the manufacturing processes of LEDs, the typical data of technical parameters can only reflect statistical figures and do not
necessarily correspond to the actual parameters of each single product which could differ from the typical data.
§ Tolerance +/- 10%
† Measured with 20mS 350mA pulse at 25˚c
Minimum and Maximum Ratings
ILS PART NUMBER Operating Temperature at
Tc-Point [˚C]*
Storage Temperature
[˚C]*
Forward Current per
chip [mA]*
Reverse Voltage [Vdc]*
ILH-ON04-DEBL-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-SIBL-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-TRGR-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-YELL-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-RDOR-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-RED1-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-HYRE-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
ILH-ON04-FRED-SC211-WIR200. 70˚C max - 40 to 110˚C 1,000mA max not designed for reverse voltage
* Exceeding maximum ratings for operating and storage temperature will reduce expected life time or destroy the LED module.
Exceeding maximum ratings for operating voltage will cause hazardous overload and will likely destroy the LED module.
The temperature of the LED module must be measured at the Tc-Point according to EN60598-1 in a thermally constant status with a temperature sensor or a
temperature sensitive label.
DATASHEET