Data Sheet
TECHNICAL INFORMATION
INFORMATION ON SERVICE LIFE
SAFETY AND INSTALLATION INFORMATION
INFORMATION ON PHOTOMETRIC AND ELECTRICAL DATA
The maximum Tc/Tp temperature is a crucial factor for the service life information relating to ledxon LED modules.
If the permitted limits are exceeded, this shall significantly reduce the service life and may even result in the destruction of the modules.
The expected service life in hours represents a purely statistical parameter.
For optimum operation of ledxon LED modules, we recommend installation only on rigid and stationary surfaces.
The heatsink must provide for sufficient heat dissipation such that the maximum permitted temperature is not exceeded at the Tc point.
The temperatures at the Tc point must be measured in accordance with the specifications stated in EN 60598-1.
When installing ledxon RIGID LED modules, the relevant specifications and standards must be observed.
The modules must be de-energised when they are being connected. The correct polarity for the connection lines must be observed
upon start-up. Incorrect polarity may result in the destruction of the LED modules. When installing these modules, standard ESD safety
precautions must be complied with. ledxon RIGID LED modules are delivered without cabling. These modules are electrified by connect-
ing leads to the provided plug terminal connection. The maximum permitted cable cross-section must be observed in this process. High
mechanical load must be avoided during installation. Powerful compression forces, in particular on the light area, result in damage to the
components as well as the conducting paths. We recommend using polyamide screws to secure the LED modules.
Capacity coordinates and tolerances in accordance with CIE 1931
Measurement environment temperature: ta = 25°
Measurement tolerance for colour coordinates (x / y) +/- 0.005
The maximum permitted operating voltage must not be exceeded. Otherwise a reduction in service life or a failure may occur.
All ledxon LED modules can be dimmed using PWM (pulse width modulation).
AREAL RIGID ADVANCE
ARAML-SW800-24V-64Q250-20-IC
5
The values and images presented are subject to change due to technical innovations, and
are provided without separate notification.
© ledxon modular GmbH
October 2017