User's Manual

Transmitter Fault Detection
If the LED light on the transmitter is fast flashing in red, then there must be the causes
as follows:
1. Some of the push buttons are jammed or stock..
2. EMS button has not been released.
3.
Fail to follow the correct Power-On procedure.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Industry Canada Notice
Operation is subject to the following two conditions: (1) this device may not cause interference and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Industry Canada Caution
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'IndustrieCanadaapplicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.