User's Manual

z Then, the transmitter will send signals for calling the pagers (#1, #2) in regular sequence.
1. Set Current Time
With this feature, you can setup current time into the Nexcall Transmitter.
z At the “Set Current Time” menu, set the hour and then press “ENTER” key.
z Set the minutes and press “ENTER” key.
z Use “#/Select” key to select AM or PM
z After the correct time is set, press the “ENTER” or “*/Menu” key to return to the main menu or press the
“CANCEL” key twice to exit the system setting menu.
2. Set Sleep Time
With this feature, you can turn off pagers at once automatically.
To turn this feature OFF
z Press “#/Select” key to turn the feature “OFF”
z Press “ENTER” to go back to the main menu.
To change the sleep time
z Press “#/Select” key to turn the sleep time “ON”
z Set the hour and then press “ENTER” key
z Set the minutes and then press “ENTER” key
z Use the “#/Select” key to select AM or PM
z After suitable time is set, press the “ENTER” or “*/Menu” key to return to the main menu or press
“CANCEL” key twice to exit the system setting menu.
Multicall Paging System User Manual
3. Range Test
With this feature, you can find out how far your transmitter will cover.
z Remove a couple of pagers from the charger base
z At the range test menu, press “#/Select” key to turn range test “ON”
z Press “ENTER” to start the range test. As soon as range test is activated you’ll notice the pagers flash once per
every 10 seconds.
4. Pre Set Message