Instructions
APP TUBE RETAINER & CAP
INSTRUCTIONS
Remove - x ” round head screw that retains bullet
feed magazine cylinder to Bullet Feed Plate. Set screw aside,
will need for step
BF5158
LEE PRECISION, INC.
4275 County Road U
HARTFORD WISCONSIN 53027
www.leeprecision.com
1
Verify set screw is installed into one end of spacer.
2
Install mag spacer with setscrew end into bullet feed plate.
Lightly finger tighten mag spacer into plate. Rotate cylinder as
you tighten. If mag spacer is tightened too far, cylinder will not
freely rotate.
3
Install appropriate sized clear tubes into bullet feed magazine
cylinder.
4
Install bullet feed magazine cylinders onto end of
clear tubes, so each end of tubes are encapsulated.
5
Use - x round head screw from step one, in
addition to the washer to thread into opposing end
of mag spacer.
6
Round retainer nut can now be installed on hex
plug. This retains the feed tubes to the Spline Drive
Adapter.
7
Connect Tube
Set screw
# BF2469
Cylinders
# BF5383
Feed Plate
# BF5384
Bullet Feed Cap
# BF5385
Hex Plug
# BF5384
Round Retainer Nut
# BF5401
Mag Spacer
# BF2152
Set Screw
# BF2469
Cylinders
# BF5383
Washer
# BF2471
- x Round HD
# FP2283
Round Retainer Nut
# BF5401
Multi tube adapter
# BF5402
Bullet feed cap
# BF5385