User's Manual

Leedarson Lighting
Inclusion Procedure
The following are the general procedures for the Z-Wave bulb to be “included” into the network:
1. Screw the CCT bulb into a standard E27 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the “inclusion”mode on your Z-wave controller or gateway.
a) This may also be done through your associated app,if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included”into your Z-Wave network.
Note: If you are using 3
rd
partyZ-Wave Controller or Gateway, please refer to 3
rd
Party’s instruction on
how to add a new devices to your network.
Note 2: If the bulb will not join the network after repeated attempts, please use the Factory Reset
procedures to clear the bulb’s settings.
1.4 Factory Reset Procedure
Physically switch the bulb on and off six (6) times for intervals of 0.5-2seconds. After the 6thtime, the
bulb will flash twice indicating that it’s successfully reset.