Use and Care Guide

Figure 11
Figure 12
Figure 13
Figure 14
12
Assembly - Hanging the Fan (continued)
□
□
□
□
Remove one screw from the connect plate (P) of fan-motor
□
assembly (G). And loosen other 2pcs screws away from 3/4 length.
Locate the key hole of light housing(H).
Place two key holes on the mounting screw loosened on the
connect plate (P).
Reattach 1pc screw through light housing (H) in place to the
connect plate (P).
Tighten 3pcs screws until light housing (H) is secure.
□
□
□
□
□
□
Remove 3pcs pre-installed screws from inside of the lightkti
pan (H).
Connect the terminal from LED module (I) and fan-motor assembly (G).
Locate 3pcs screw holes of LED module (I).
Place three screws holes between LED module (I) and light housing (H ).
Reattach 3pcs screws through the screw holes of LED module (I).
Tighten the screws until LED module (I) is secure.
Install the light housing Install the LED module
9
8
CAUTION: To reduce the risk of electric shock, disconnect the
electrical circuit to the fan before installing light kit.
screws