Use and Care Guide

Figure 2
Figure 3
Figure 4
Attaching the coupling cover, and
3
canopy to the downrod
Slip the coupling cover (F), canopy cover (C) and
canopy (B) onto the downrod (E). Carefully reinstall the
hanger ball (D) onto the downrod (E), and ensure that
the cross pin (MM) is in the correct position, the hanger
ball set screws (NN) are tight, and the wires are not
twisted.
Hanging the fan motor assembly
4
from the mounting bracket
□
Lift the fan motor assembly (H) into position, and place
the hanger ball (E) into the mounting bracket (B). Rotate
the fan motor assembly (H) until the check groove drops
into the registration slot and seats firmly. The downrod (F)
should not rotate if this is done correctly.
□
Loosen the two fan motor assembly coupling set screws
(QQ) from the fan motor assembly (G) coupling.
□
□
Remove the hitch pin (PP) and lock pin (OO) from the
downrod (E). Remove the hanger ball (D) from the
downrod (E) by loosening the hanger ball set screw
(NN), and removing the cross pin (MM), then sliding
the hanger ball (D) o ffof the downrod (E).
Attaching the downrod to the
Thread the downrod (E) into the fan motor assembly (G)
coupling. Line up the holes and replace the lock pin (OO)
and the hitch pin (PP).Tighten the set screws (QQ).
A
fan motor assembly
Carefully feed the fan wires up through the downrod(E).
2
8
Assembly - Hanging the Fan (continued)